Goods main bearings

All your power station questions answered. Posting restricted to registered users.
Post Reply
dinogt
Posts: 6
Joined: Thu Feb 07, 2019 9:40 am
AntiSpam: No
Location: France
Contact:

Goods main bearings

Post by dinogt » Thu Feb 07, 2019 4:28 pm

Hi at every body
I am Dino from France.
I have not any 400NS but I work on crankshafts and cylinders
I have a problem with bearings because I have a dismounted crank (it is not me who have dismounted) and... by mistake I threwed the main bearing with pin and groove for model (of one before crank).

The origine bearings are not like 350RZ or 250RGV bearings,
_the groove of bearings 83580-9c3 (250RGV) or 83406-9c3 (350rz) is not at good place and the pin (I think) also.
_the pin of the 83406A is not at the same place than the origin 83B009 (0.8mm difference from the axe), I have one for model.

So, is some one here, have 1 groove main bearing in plan or photo to do good sizing groove and pin?
I hope you understand all my good frenchinglish writen.
thanks
Dino
Bleu smoke at the horizon

https://www.dinogt.fr/

User avatar
Alastair
Posts: 1780
Joined: Sat May 25, 2002 1:01 am
Location: Glossop U.K.
Contact:

Re: Goods main bearings

Post by Alastair » Sun Feb 10, 2019 7:53 pm


dinogt
Posts: 6
Joined: Thu Feb 07, 2019 9:40 am
AntiSpam: No
Location: France
Contact:

Re: Goods main bearings

Post by dinogt » Fri Feb 15, 2019 9:53 pm

On their photo it is impossible to see what is written on the bearings but... as I think that goods news bearings does not exists, I have same bearings at home less expensive (I sell them 80€ the four bearings)
I just need origin groove bearing measurement
Bleu smoke at the horizon

https://www.dinogt.fr/

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests